LDIDA Basic 3-Floor Lift Vocational Training Equipment Mechatronics Training Equipment
Trainer mod. LDIDA has been designed to simulate a 3-floor lift commonly used in multi-storey buildings.
TRAINING PROGRAM:
- System analysis
- System I/O setup
- Process flow diagram generation
- Step-by-step sequence
- Logical process flow diagram generation
- Evaluation of potential problems
- Program development
TECHNICAL SPECIFICATIONS:
Electric characteristics
- 10 limit switches
- 9 LEDs signaling the cabin at the floor
- 3 LEDs signaling the cabin speed and direction of travel(up/down)
- 4 requested floor buttons
- 9 LEDs signaling the lift status at the floor (free/busy/alarm)
- 3 switches simulating if the cabin door status at the floor(open /closed)
- 6 LEDs signaling the cabin door status at the floor (open /closed)
- 1 diverter switch reproducing the open /closed cabin doorstatus
- 2 LEDs signaling if the cabin door is open or closed
- 1 LED to light the cabin
- 3 floor request buttons
- 1 emergency stop button
- 1 alarm button
- 3 LEDs signaling the position at the floors
- 1 LED signaling an alarm status
- 1 Buzzer signaling an alarm status
- 1 DC gear motor
- Connection to the PLC by means of Ø 2 mm terminals
Mechanic characteristics
- Silk screen synoptic
- Vertical aluminum frame with interface box
- DC gear motor coupled to a system of pulleys with a belt forthe cabin motion
A PLC (not included) is needed to control the process. Minimum requirements:
- 23 24 Vcc digital inputs
- 14 24 Vcc 0,5 A digital outputs
Suggested PLC:
- 1 PLC training panel mod. PLC-V8 with 16 DI / 16 DOExpansion mod. V8-1
Or, as alternative:
- 1 PLC training panel mod. PLC-V6
Power Supply: 24 Vcc – 0.5A (supplied by the PLC)
Dimensions: 655 x 297 x 100 mm
Weight: 3 kg