FCBp Flow-Rate Control Vocational Education Equipment for School Lab Flow Control Training Equipment
This bench top unit enables to carry out several tests of flow-rate control and it can be connected with the water network or with the laboratory line of compressed air to reproduce the flow-rate control of a gas or of a liquid.
TRAINING PROGRAM:
This unit enables to develop and analyze the following subjects:
- Proportional, Integral and Derivative control
- Open-loop control
- Closed-loop control
- Tuning a controller
- Response to a noise
TECHNICAL SPECIFICATIONS:
- Framework of AISI 304 stainless steel
- Electronic differential-pressure transmitter of AISI 316stainless steel, with 4 to 20 mA output signal
- Calibrated orifice of AISI 304 stainless steel
- Pneumatic control valve of AISI 316 stainless steel, Cv = 2.5
- Electro-pneumatic converter, 4 to 20 mA / 0.2 to 1 bar
- Safety valve
- Bourdon gauge of stainless steel with range of 0 to 6 bar
- Pressure gauge for measuring the output signal of I/Pconverter
- Switchboard of painted carbon steel with synoptic, ELCBand measuring terminals for input and output signals of thecontroller
- Pipes and valves of AISI 304 and 316 stainless steel
- This unit can be connected in with module mod. PCBp forthe simultaneous control of pressure and flow rate
- Industrial PLC placed in the electrical board, including thePID control block and Ethernet communications module.
It is included the standard IEC 1131 61131 programming software.
- Operator Panel, 7” TFT touchscreen display, 16 millioncolors, 800 x 480 pixels, with RJ45 PROFINET ports; the H.M.I(Human Machine Interface) industrial supervision software is included.
Power Supply: 230 Vac 50 Hz single-phase – 0,5 kVA (Other voltage and frequency on request)
Dimensions: 850 x 600 x 750 mm
Net Weight: 50 kg