AFM024P Flow-Rate and Pressure Control (including PID Controller with Software) with Computer and Backup UPS
Objectives of the Equipment
The equipment should be able to demonstrate the followings:
- Proportional, Integral and Derivative control
- Measuring instruments of pressure and flow rate
- Response and characteristics of process
- Tuning techniques of controllers
- Controlling flow-rate and pressure of gases and of liquids
- Split-range control
Specifications/Provisions (or equivalent)
The unit must be equipped with (or corresponding part):
- Framework: Stainless steel or anodized aluminum with enough thickness to withstand the load of equipment and/or different components of equipment
- Storage tank with capacity of 40 l (Minimum)
- Centrifugal pump (Made up of corrosion-resistant material)
Q = 0.5 m3 /h (Minimum)
Head of 20 m (Minimum)
- Compressor (along with female valves of 1» 4”) for the requirement of compressed air (1 Nm3 /h @ 6 bar, for instruments, and 50 Nm3 /h @ 6 bar, when air is used as process fluid)
- Tap water valve with 1/2” hose connector
- Transparent flow meter
- Flow measuring device
- Calibrated diaphragm
- Electronic magnetic induction flow transmitter
with 4 to 20 mA output signal
- Electronic variable area flow transmitter-indicator with range of 20 to 2000 l/h and 4 to 20 mA output
- Electronic differential-pressure transmitters of with 4 to 20 mA output signal
- Pneumatic control valves for pressure control in splitrange and flow rate control
- Electro-pneumatic converters, 4 to 20 mA / 0.2 to 1 bar
- Electronic pressure transmitter of with range of 0 to 6 bar and 4 to 20 mA output signal
- PID controller
- Piping and valves
- Safety control
- Automated unit along with software for computerized control of the equipment
- Computer
- UPS with enough backup for shutting down the unit/equipment in case of power failure
- List of spares (for 1 year)